小型搅拌机液压转动系统使用要求?
来源:http://www.zkhntjbj.com/日期:2020-08-24
小型混凝土
搅拌一体机是常见的运输混凝土,黏土的一种运输工具,在运输途中应该确保无误,整个过程中混凝土以及泥土都会得到搅拌,这样直到到达了目的地,混凝土以及黏土的质量还是能够保持良好。其液压转动系统使用要求如下:
The small-scale concrete mixer is a common transport tool for transporting concrete and clay. It should be ensured that there is no error during the transportation. During the whole process, the concrete and soil will be mixed, so that the quality of concrete and clay can be maintained well until the destination is reached. The operation requirements of its hydraulic rotation system are as follows:
1、新车开始使用前,首先检查和清除液压系统各处的灰尘和杂物,并检查各处连接是否正确和有无其它问题。
1. Before the new car starts to use, first check and remove the dust and debris around the hydraulic system, and check whether the connection is correct and whether there are other problems.
2、油箱中装液压油到油标刻度线以上,泵壳和马达壳内也要充油。
2. The oil tank is filled with hydraulic oil above the oil mark, and the pump housing and motor housing should also be filled with oil.
3、启动发动机,操纵伺服手柄使小型混凝土搅拌一体机拌筒在低速下正转,观察液压系统是否正常工作。
3. Start the engine, operate the servo handle to make the mixing drum of small-scale concrete mixing machine rotate forward at low speed, and observe whether the hydraulic system works normally.
4、油温不得超过60℃,泵壳压力必须小于0.25MPa。
4. The oil temperature should not exceed 60 ℃, and the pump shell pressure must be less than 0.25MPa.
5、注意散热器上的风扇在50℃-70℃范围内应是运转状态。风扇发生故障不运转时,应及时修理。
5. Note that the fan on the radiator should be in operation state within the range of 50 ℃ - 70 ℃. When the fan fails to work, it should be repaired in time.
6、补油泵溢流阀、低压溢流阀、高压溢流阀压力出厂时已调定,不得随意改动。
6. The pressure of relief valve, low-pressure relief valve and high-pressure relief valve of make-up oil pump has been set before delivery and shall not be changed at will.
7、小型混凝土搅拌一体机油路中各部件及管路不得有漏油现象,如发生渗漏,应及时修理。
7. There shall be no oil leakage in all parts and pipelines of small-scale concrete mixing integrated oil pipeline. In case of leakage, it shall be repaired in time.
8、工作运转状态时,不得随意修理和调整。
8. It is not allowed to repair and adjust at will when working.
9、液压油泵、马达若发生故障需及时更换下来送专业指定维修部修理。
9. If the hydraulic oil pump and Mada fail, they should be replaced in time and sent to the professional designated maintenance department for repair.
We should do a good job in all aspects of the inspection when driving the small-scale concrete mixing machine. The hydraulic rotation system is a very important part of the whole mixing machine. Only when the hydraulic rotation system meets the requirements can we use the mixing machine efficiently. If you want to know more about blenders, please click here http://www.zkhntjbj.com Website.