Since the charging mixer is a construction site vehicle, this kind of vehicle is relatively large, so before you leave the car, you must pay attention to check, in case of emergency, the following automatic charging mixer manufacturer to take you to understand.

1、仔细检查及时发现扫除毛病。

1. Check carefully and find out and remove the defects in time.

千万不能让自动上料搅拌机坏在路上，否则呈现闷罐就费事了，混凝土普通停罐不能超越2个小时，C40往上级别的混凝土根本就不能停。点火之前先检查机油、防冻液、光滑油和冷却水等，发现缺乏时，应重新停止添加。车子启动后，再让罐子低速旋转，盘绕着车检查轮胎气压，能否有漏气的胎，再用螺丝刀剔掉在胎缝里的石子，检查能否有铁钉之类扎在胎里!

Do not let the automatic feeding mixer break down on the road, otherwise it will be troublesome if the tank is closed. The ordinary stopping time of concrete can not exceed 2 hours, and the concrete with C40 grade cannot stop at all. Before ignition, check the engine oil, antifreeze, smooth oil and cooling water, etc., and stop adding them again when they are found to be short. After the car starts, let the jar rotate at a low speed, coil around the car to check the tire pressure, whether there is a leak tire, and then use a screwdriver to remove the stones in the tire seam to check whether there are iron nails or other things stuck in the tire!

再检查灯光，特别是腰灯，务必保证照着轮胎边缘，工地会经常乱堆放钢筋之类的东西，而胎侧是很单薄的。用抹布擦洁净两边的后视镜，窗户玻璃，工地路况复杂，光线不好，视野一定要首先保证! 自上料搅拌机

Check the light again, especially the waist lamp. Make sure to shine on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is very thin. Clean the rear-view mirror and window glass on both sides with dishcloth. The road conditions are complex and the light is not good. The vision must be guaranteed first.
               

2、保证水箱里有足够的水，有减水剂，因各种缘由料太干，没有水添加放不出料的时分，减水剂就是救命稻草了。

2. Ensure that there is enough water in the water tank, there are water reducing agent, because of various reasons, the material is too dry, there is no water to add, when the material can not be discharged, the water reducing agent is life-saving straw.

3、确认搅拌罐处于中止状态，由于发起机启动时万一罐子处于高速旋转状态，霎时的力会很大的，伤减速机。

3. Make sure that the mixing tank is in the stop state. If the tank is in the high-speed rotation state when the starter is started, the force will be very large and the reducer will be injured.

4、无论是将手柄从搅拌到排放还是从排放到搅拌，都应使其中止在中止位置，然后拨到下一个操作位置。

4. Whether it is from mixing to discharging or from discharging to mixing, the handle should stop at the stop position and then move to the next operation position.

以上就是关于自上料搅拌机在出车前以及装料时要留意的问题，相信大家都有所了解了，如您想要理解更多资讯内容请点击网站：自动上料搅拌机多少钱http://www.zkhntjbj.com。

The above is about the charging mixer in the car before and loading to pay attention to the problem, I believe you have understood, if you want to understand more information, please click the website: how much is the automatic feeding mixer http://www.zkhntjbj.com 。