小型搅拌机残渣的处理办法!
来源:http://www.zkhntjbj.com/日期:2021-02-03
小型搅拌机突然出现问题需要停放的时候,若没有及时将搅拌罐内的残渣整理出来,时间一久混凝土就会凝结,不只会形成经济损失,也会给后续的作业带来许多许多的麻烦,小编告知你整理罐体混凝土的两种办法。
When the small mixer suddenly has problems and needs to be parked, if the residue in the mixing tank is not sorted out in time, the concrete will set after a long time, which will not only cause economic losses, but also bring a lot of troubles to the follow-up operation. Xiaobian tells you two ways to sort out the concrete in the tank.
残渣的处理办法一:
Treatment method 1 of residue:
准备好紧迫驱动软管,将问题小型混凝土搅拌机熄火,卸下液压马达上的高压油管接头。将救援车熄火,将其液压马达的高压油管卸下,并与问题车上的对应接头用紧迫驱动软管相连。发起救援车,将其操作手柄拨至出料方位,问题车内的混凝土即被排出。紧迫驱动结束后,将驱动软管卸下,并恢复两车原状。
Prepare the emergency drive hose, turn off the small concrete mixer, and remove the high-pressure oil pipe connector from the hydraulic motor. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the problem vehicle with an emergency drive hose. Launch the rescue vehicle, turn its operating handle to the discharging position, and the concrete in the problem vehicle will be discharged. After the emergency drive, remove the drive hose and restore the two vehicles to their original state.
残渣的处理办法二:
The second method is to treat the residue
假如上种办法实施有困难,则有必要选用以下办法,当即排出混凝土。在小型混凝土搅拌机残渣的处理托轮和滚道之间放入木楔,以操控搅拌筒的旋转,必定要注意安全;将发起机熄火,拆松液压马达的一根高压油管,搅拌筒可自在旋转,操控搅拌筒的旋转,使修理孔转到下部,然后翻开修理孔,整理出筒内混凝土。混凝土排出结束后,恢复小型混凝土搅拌机残渣的处理的原状。
If the above method is difficult to implement, it is necessary to select the following methods to discharge the concrete immediately. In order to control the rotation of the mixing cylinder, we must pay attention to safety by putting a wedge between the supporting wheel and the raceway of the small concrete mixer residue treatment. Turn off the engine, remove a high-pressure oil pipe of the hydraulic motor, and the mixing cylinder can rotate freely. Control the rotation of the mixing cylinder to turn the repair hole to the lower part, and then open the repair hole to sort out the concrete in the cylinder. After the concrete is discharged, the residue of the small concrete mixer shall be restored to its original state.