In the long-term use of mechanical equipment, in order to maintain its good operating performance, we need to lubricate it irregularly. So what should we pay attention to in the process of adding lubricating oil to the equipment?

1、搅拌一体机在运转过程中不得检修和润滑。

1. It is not allowed to overhaul and lubricate the mixer during operation.

2、定期向各黄油嘴加注黄油，轴端密封处每4小时注润滑油一次，每周排污一次。

2. Fill grease to each grease fitting regularly, fill lubricating oil into the shaft end seal every 4 hours, and drain water once a week.

3、搅拌一体机在使用后酌情对各润滑点加注必要的润滑油（滚轮轴、滚轮、钢丝绳等活动部位）。

3. After use, add necessary lubricating oil (roller shaft, roller, wire rope and other moving parts) to each lubricating point as appropriate.

4、搅拌一体机减速箱的齿轮和轴承是利用齿轮回转将机油飞溅到箱体内壁，流入轴承中去进行润滑的。减速箱的油面应保持在油标尺两刻线之间为宜。油面过高或过低会导致各部温度升高或润滑不良，增加功率损耗和造成机器工作不良。

4. The gear and bearing of the gearbox of the mixer are lubricated by splashing the oil on the inner wall of the box body and flowing into the bearing. The oil level of reducer should be kept between the two lines of oil scale. If the oil level is too high or too low, the temperature of each part will rise or the lubrication will be poor, the power loss will increase and the machine will work poorly.
                

5、搅拌一体机选用的润滑油应具有一定购粘度和粘温特性，凝点低，抗氧化安定性良好，没有机械杂质和水分，不合腐蚀和磨损物质等。其质量指标应符合国家标准规定。

5. The lubricating oil selected for all-in-one mixer should have certain viscosity and viscosity temperature characteristics, low freezing point, good anti-oxidation stability, no mechanical impurities and moisture, no corrosion and wear substances, etc. The quality index should conform to the national standard.

搅拌一体机进行润滑工作是为了能有效减少磨损，提高元部件的使用寿命。不过在进行添加润滑油的过程中也要注意一些事项，新机开始使用头150小时和300小时要分别更换机油一次，以便排除试车时未完全洗净的污物。工作时，要经常检查油面高度，不足应及时添补。

In order to reduce the wear and improve the service life of the components, the lubrication of the mixer is carried out. However, in the process of adding lubricating oil, we should also pay attention to some matters. In the first 150 hours and 300 hours of use of the new machine, the engine oil should be changed once, so as to remove the dirt that is not completely cleaned during the test run. When working, the height of oil level should be checked frequently, and the shortage should be supplemented in time.