欢迎您访问莱州聚峰机械有限公司网站!
点击拨打服务热线:400-879-1999
大家都在搜: 铲斗外翻 3.5吨A后侧 3.5吨A后尾

检查搅拌一体机的油耗有判断方法

来源:http://www.zkhntjbj.com/日期:2022-07-20

概述:早上,当搅拌一体机冷启动时,注意检查排气管的出口。如果刚刚启动时排气管冒出蓝烟,说明搅拌机在烧油。这种方法很好由两个人来完成,一个
早上,当搅拌一体机冷启动时,注意检查排气管的出口。如果刚刚启动时排气管冒出蓝烟,说明搅拌机在烧油。这种方法很好由两个人来完成,一个是启动搅拌机,另一个是负责调查。因为蓝烟的时间很短,只有在搅拌机放置较长时间后才会出现。
In the morning, when the all-in-one mixer is cold started, pay attention to check the outlet of the exhaust pipe. If the exhaust pipe emits blue smoke when it is just started, it indicates that the mixer is burning oil. This method is well done by two people, one is to start the mixer, the other is responsible for the investigation. Because the time of blue smoke is very short, it will appear only after the mixer is placed for a long time.
当油门开高时,会冒出蓝烟。当搅拌机快速加速或将加速器吹到适当位置时,会发出蓝烟,但不是在怠速下。这种情况说明搅拌机烧机油,现在很严重,应该尽快修理。
When the throttle is turned high, blue smoke will appear. When the mixer accelerates rapidly or the accelerator is blown to the appropriate position, blue smoke will be emitted, but not at idle speed. This situation shows that the mixer burns oil, which is very serious now, and it should be repaired as soon as possible.
搅拌机的机油入口冒出蓝烟。除排气口外,搅拌机的发动机进油口还冒出蓝烟。经查明,症状已到中晚期,机油燃烧十分严重。必须尽快送去修理,以免造成更大的损坏。
Blue smoke came from the oil inlet of the mixer. In addition to the exhaust port, the engine oil inlet of the mixer also emits blue smoke. After investigation, the symptoms have reached the middle and late stage, and the engine oil combustion is very serious. It must be sent for repair as soon as possible so as not to cause greater damage.
搅拌一体机
搅拌一体机筒体密封性差是造成燃油燃烧的主要原因。主要原因是活塞与缸壁间隙过大,活塞环安装不当或密封性差,缸壁上的油进入燃烧室,造成油燃烧。
The poor sealing of the mixing machine cylinder is the main reason for fuel combustion. The main reasons are that the clearance between the piston and the cylinder wall is too large, the piston ring is improperly installed or the sealing is poor, and the oil on the cylinder wall enters the combustion chamber, causing oil combustion.
如何搅拌车燃油燃烧问题?尽量选用机油。旧混凝土搅拌车可以使用粘度稍高的机油来增加活塞与筒壁之间的密封。矿物发动机油使用时间长,使用全组分发动机油后容易出现密封不严的情况。
How to solve the fuel burning problem of mixer truck? Try to use high-quality engine oil. The oil with slightly higher viscosity can be used in the old concrete mixer to increase the sealing between the piston and the cylinder wall. Mineral engine oil has been used for a long time, and it is prone to loose sealing after using full component engine oil.
经常检查搅拌一体机的油垢,定期更换搅拌机的油和滤油器,更换原装滤油器的备件,选用原厂的油等,可避免搅拌机的烧油现象。
Regularly check the oil dirt of the mixer, regularly replace the oil and oil filter of the mixer, replace the spare parts of the original oil filter, and select the original oil, etc., so as to avoid the oil burning phenomenon of the mixer.
检查搅拌一体机的油耗有判断方法便是以上讲解了,您可以作为参考使用,当然也要注意一些事项,防止有意外发生,更多内容就来网站http://www.zkhntjbj.com咨询看看吧。
There are ways to check the fuel consumption of the mixing machine, which is explained above. You can use it as a reference. Of course, you should also pay attention to some matters to prevent accidents. For more information, please visit the website http://www.zkhntjbj.com Consult and have a look.

截屏,微信识别二维码