混凝土搅拌机在冬季低温环境下不易启动，一直是广大朋友们共同面临的难题。今天，小编就低温启动常见的一些误区给大家做一个盘点，相信对于经验丰富的朋友们，会是一次温故知新，对于了解不多的朋友们，将会是一笔宝贵的经验。

The concrete mixer is not easy to start under the low temperature environment in winter, which has been a common problem faced by many friends. Today, I will make an inventory of some common mistakes in low temperature startup. I believe that it will be a valuable experience for experienced friends to review the past and learn the new.

打不着火连续启动

Continuous start without ignition

冬季车辆电瓶耗电量较大，电瓶在晚上停车之后一般还会放电，启动时打不着火，连续启动更会损坏电瓶。建议朋友们在停车之前及时关闭耗电装置，再关闭发动机。车辆在启动发动机预热后再打开空调、收音机，以延长电瓶寿命。

In winter, the battery of the vehicle consumes a lot of electricity. The battery will generally discharge after parking at night. The battery will not catch fire when starting. Continuous starting will damage the battery even more. It is recommended that friends turn off the power consumption device in time before parking, and then turn off the engine. After the vehicle is warmed up by starting the engine, turn on the air conditioner and radio to extend the battery life.

启动后猛踩几脚油门

After starting, step on the accelerator

不少搅拌机司机在冬季车辆启动后，会猛踩几脚油门，这其实对车辆有严重的损伤：1、这样不但耗油，而且会加剧发动机的磨损。2、容易导致滤芯膨胀，甚胀破。总之，冷启动后猛踩油门对发动机的各项性能有百害而无一利。正确的操作是在发动机的温度升高到40摄氏度以后再适当加油门。

Many blender drivers will step on the accelerator several times after the vehicle starts in winter, which actually causes serious damage to the vehicle: 1. This not only consumes fuel, but also increases the wear of the engine. 2. It is easy to cause the filter element to expand or even burst. In a word, stepping on the accelerator after a cold start is harmful to the performance of the engine. The correct operation is to increase the temperature of the engine to 40 ℃ before the proper fuel valve.

过分依赖启动液

Excessive dependence on starting fluid

车子在户外放置时间过久，发动机各摩擦部件之间都会出现无润滑油情况，各摩擦部件表面都处于干摩擦状态。此时若用冷启动液助启动的话，发动机顿时点火产生很大冲击力，必定磨损量很大，若喷的启动液过多还会造成冷拉缸或烧瓦事故。

If the car is left outdoors for too long, there will be no lubricating oil between the friction parts of the engine, and the surfaces of the friction parts are in a dry friction state. At this time, if the cold starting fluid is used to assist the starting, the engine will immediately ignite and produce a great impact, which will certainly cause great wear. If too much starting fluid is sprayed, it will also cause cold cylinder drawing or bush burning accidents.

正确方法应该是在使用冷启动液之前，对油箱和油底壳进行一定的预热，使发动机内各运动部件得到良好润滑，安装油箱加热器进行预热，可以使用喷灯进行加热但不建议使用明火，毕竟明火存在很大的隐患。

The correct method should be to preheat the oil tank and oil pan to a certain extent before using the cold starting liquid, so that all moving parts in the engine can be well lubricated. Install the oil tank heater for preheating. You can use a blowtorch for heating, but it is not recommended to use an open flame. After all, open flame has a great potential safety hazard.

无论哪种发动机在寒冷的冬天难免遇到发动困难的情况，越是到这种时候就越应该避免鲁莽操作，养成良好习惯，对自己的爱车负责，是作为一名合格搅拌机司机的必备条件。更多相关内容就来我们网站http://www.zkhntjbj.com咨询吧！

No matter what kind of engine is difficult to start in cold winter, the more this time comes, the more you should avoid reckless operation, develop good habits, and be responsible for your car, which is a prerequisite for a qualified mixer driver. More relevant content will come to our website http://www.zkhntjbj.com Consult!