混凝土搅拌机运行时间过长出现高温的
来源:http://www.zkhntjbj.com/日期:2022-11-25
由于长时间连续运行,混凝土搅拌机的温度会升高,但如果温度超过了
混凝土搅拌机本身的能力,设备就会受到一定程度的损坏。因此,当设备温度过高时,我们需要做好相应的维护工作,下面就来了解一下吧。
The temperature of the concrete mixer will rise due to continuous operation for a long time, but if the temperature exceeds the capacity of the concrete mixer, the equipment will be damaged to some extent. Therefore, when the temperature of the equipment is too high, we need to do a good job in the corresponding maintenance. Let's take a look.
1,身体为了防止发动机过热:
1. To prevent the engine from overheating:
由于环境温度高,发动机容易过热,加强发动机冷却系统的检查和维护,包括水箱、恒温器、水泵、风扇和其他部分的检查,注意及时注入冷却水。当水温超过100℃时,在阴凉处停车降温,让发动机空转,打开引擎盖帮助加热。
Due to the high ambient temperature, the engine is easy to overheat. Strengthen the inspection and maintenance of the engine cooling system, including the inspection of water tank, thermostat, water pump, fan and other parts, and pay attention to the timely injection of cooling water. When the water temperature exceeds 100 ℃, stop in the shade to cool down, let the engine idle, and open the engine hood to help heating.
2、防止发动机爆燃:
2. To prevent engine detonation:
夏季温度较高,有时超过35℃,而这个季节,对于一些部分老化的汽车,自然爆燃的概率也要高得多。所以做好准备。
The temperature is higher in summer, sometimes exceeding 35 ℃. In this season, the probability of natural deflagration is much higher for some partially aged cars. So get ready.
![混凝土搅拌机](http://www.zkhntjbj.com/uploadfile/2022/1111/20221111045537313.jpg)
3、防止对车漆的损伤:
3. To prevent damage to the paint:
车漆经过强烈的日晒,老化、起皱,而普通的美容打蜡虽然能起到一定的防晒作用,但因为任何车蜡都含有硅成分,经过紫外线照射会使车漆生锈,留下小黑点。车蜡本身并没有起到增强硬度、抗紫外线的作用,但会因温度过高而迅速丢失,停车时要注意将车停放在阴凉处。
The car paint is subject to strong sunlight, aging and wrinkling. Although ordinary cosmetic waxing can play a certain role in sun protection, it will rust and leave small black spots after ultraviolet radiation because any car wax contains silicon. The car wax itself does not play a role in enhancing the hardness and anti UV, but it will be quickly lost due to high temperature. When parking, pay attention to parking the car in a cool place.
4、防止爆胎:
4. Prevention of tire blowout:
高温易爆胎,高温易使轮胎变形,耐跌落。但是由于轮胎本身,气压不达标,轮胎老化,性能变弱,或者在行驶过程中轮胎碰到坚硬的金属或其他坚硬的东西,都会导致汽车的轮胎突然瘪掉。
High temperature is easy to burst, high temperature is easy to deform the tire, and it is resistant to falling. However, due to the tire itself, the air pressure is not up to standard, the tire is aging, its performance becomes weak, or the tire encounters hard metal or other hard things during driving, it will cause the tire of the car to suddenly deflate.
We have explained the solution to the problem of high temperature caused by the long operation of the concrete mixer from four aspects. You should pay attention to prevention and inspection before and after reuse. Problems often occur in carelessness and fluke. Come to our website for more information http://www.zkhntjbj.com Ask and understand!