There are always some small problems in the long-term use of the full-automatic feeding machine. At this time, as an equipment manager, what should we do? Wait for the manufacturer to repair and delay the production. As the saying goes, it's better to ask others than yourself. Some simple small problems can be solved by yourself. The most common problem of the full-automatic feeder is that when the pneumatic pump is used as the vacuum source, the materials may not be sucked up. There are still many reasons for this, mainly in the following aspects.

可以先检查控制系统有没有问题，比如说全自动上料机的各个参数，吸料，放料的时间是准确无误的，要是在这里有问题吸料机就有或许不能正常的吸料，应及时的进行更改处理。

You can first check whether there is a problem with the control system. For example, the parameters of the full-automatic feeding machine, the time of suction and discharge are accurate. If there is a problem here, the suction machine may not be able to suck normally and should be changed in time.

对设备的气动泵进行检查，看看它的压缩空气的管路的接口是否有配合。大部分情况下气动泵的气源压力是在6到7mpa，要是管路连接正常，就应该检查一下气源的气动泵。

Check the pneumatic pump of the equipment to see whether the interface of its compressed air pipeline is matched. In most cases, the air supply pressure of the pneumatic pump is 6 to 7MPa. If the pipeline connection is normal, you should check the pneumatic pump of the air supply.

吸料机不能正常的进行吸料也有或许是因为机器的拆装移动，在上盖和筒体卡箍出现漏气的情况，从而导致正常进行吸料作业。

The suction machine can not suck the material normally, or it may be due to the air leakage in the upper cover and cylinder clamp due to the disassembly and movement of the machine, resulting in the normal suction operation.

全自动上料机

Automatic feeding machine

将上料机的上盖代开，把过滤板拿出来往后调查在滤芯上面的灰尘杂质是不是太多了，或许有的灰尘已经结成了固体的凝块，这种情况都会让吸料机以不正常的压力进行吸料，出现这种问题，只要用气枪吹扫干净就可以了。

The upper cover of the feeder is replaced, and the filter plate is taken out to investigate whether the dust impurities on the filter core are too much. Maybe some of the dust has already formed solid clot, which will cause the suction machine to absorb the material under abnormal pressure.

对全自动上料机的吸料管道进行检查，是不是上面出现了漏气，其他要注意地方就是所有的卡箍上面是不是都有密封圈且密闭圈无老化、无漏气。在检查的时分可以依据上面的顺序来进行，假如发现某一段问题的把它换掉或许是清洁干净就可以了，要是仍是找不到原因的话可以找相关的人员或者联系厂家来进行检查和维护。

Check whether there is air leakage on the suction pipe of the full-automatic feeding machine. Other points to pay attention to are whether there are sealing rings on all clamps, and the sealing rings are free of aging and air leakage. During the inspection, it can be carried out according to the above sequence. If you find a problem, replace it, perhaps clean it. If you still can't find the reason, you can find relevant professional personnel or contact the manufacturer for inspection and maintenance.